OC-50 Dieselcraft centrifuge WVO / biodiesel vegetable oil cleaning rig


this is how i clean my oil after settleing for over a month. I run it approximately one hour at 80psi, starting at 160 degrees getting above 212 degrees to get all the water out. Then I pan test the oil in a cast iron pan to be absolutely sure there is no suspended water left in the oil. I run a single tank, chevy k5, with a 6.2l diesel motor. I use poly tanks and blend 20% diesel back in for all year operation. Also i use a Racor 1000 filter with a built in 300 watt electric heater that gets up to 160 degrees. First I preheat my injection line heaters (4x100 watts), for approx 2 minutes before glow plugging and starting up. Injection line heaters are run on a seperate temp regulated circuit that i monitor on my dash. They run at approximately 150 degrees full time. Of course once my filter heater gets going they cycle very little.
From:
MrFutant
Views:
3254

3
ratings
Time:
03:00
More in
Autos & Vehicles